WHEELS-BRAKES-
SUSPENSIONS
6
Swing arm removal
Lift the bike from the ground with a proper central stand.
Before proceeding to remove the swing arm it is necessary to remove the following particulars:
- rear fender and chain guard
- real wheel
- rear brake
- exhaust manifold of vertical cylinder
- mono shock absorber
- release the swing arm from the connecting rods of the rear suspension arm
Unscrew and remove the special screws (27) from both engine plates (28).
If necessary loosen the three lower screws of the engine plates to make easier the removing of the
swing arm.
Slip the swing arm pivot (1) off and remove the swing arm (5).
Sub 6-19
To Next Page
Loading...
