USE
MAINTENANCE
3
CAUTION
During the filling operation always maintain the oil liquid above the MIN to prevent formation air
bubbles in the circuit.
Drain the oil from bleeding valve (2) until the leakage of liquid of different colour. Re-screw the
bleeding valve (2) and tighten to the recommended torque wrench and restore the proper oil level
into the reservoir.
Clutch liquid draining
CAUTION
The fluid used in the clutch system, apart damaging the paint, is very damaging in contact of eyes
and skin; wash thoroughly with running water, the interested parts in the event of accidental
contact.
Remove the protective cap place above the draining valve (2).
Connect to the draining valve (2) a bleeding device.
Loosen the draining valve and pump with the bleeding device until no more fluid leaks from the
circuit.
In case of a bleeding device is not available, connect a transparent plastic hose to drain valve (2)
then dip the other end in a container placed on the floor and containing clutch exhausted fluid.
Screw (¼ of turn) the bleeding valve.
Remove the cap (1) with membrane from the fluid reservoir.
Sub 3-28
To Next Page
Loading...
