USE
MAINTENANCE
3
Proceed to its cleaning with compressed air and fuel being careful not to tear the net. Replace the
filter net (8), the seal (7) and OR seal (9) on the cap (6).
Remove the load cap (2) and fill with the prescribed oil to up to the mark which identify the MAX
level on the inspection window.
Close the cap and run the engine, idling for a few minutes.
Verify that there are not oil leaks and that the oil pressure indicator light on the dashboard goes off
after a few seconds from engine switch. Otherwise, stop the engine and perform the necessary
checks.
After a few minutes check that the oil level corresponds to the prescribed and if necessary restore
the MAX level.
Reassembly the removed structures.
Sub 3-11
To Next Page
Loading...
