USE
MAINTENANCE
3
Press the pedal two or three times so as to allow the circuit to go under pressure.
Keep the pedal pressed.
Connect a transparent hose to the draining valve (5) then dip the other end in a container placed in
the floor .
CAUTION
During the filling operation keep the oil level above the MIN mark to prevent the formation of air
bubbles inside the circuit.
Drain the oil from the draining valve (5) until the leakage of liquid of different colour.
Re-screw the draining valve (5) and restore the proper level of oil tank.
Put the cap (4) screwing it on the reservoir.
Sub 3-21
To Next Page
Loading...
