4 en | Table of contents Control Panels
2018.07 | 16 | F.01U.287.180 Installation Manual Bosch Security Systems, Inc.
7.3 Telephone line monitor 30
7.4 Called party disconnect 30
7.5 Communication failure 31
8
IP communications 32
8.1 On-board Ethernet connection 32
8.1.1 Supervision 32
8.1.2 Local programming 32
8.1.3 On-board Ethernet diagnostic LEDs 33
8.2 Conettix Plug-in cellular modules 34
8.3 B426 Ethernet Communication Module 34
8.3.1 Address and emulation settings 34
8.3.2 Supervision 34
8.3.3 B426 module faults 34
8.3.4 Installation and control panel wiring (B426) 35
8.3.5 Diagnostic LEDs 36
8.3.6 Local programming 38
8.4 B450 Conettix plug-in communicator interface 38
8.4.1 SDI2 address settings 38
8.4.2 Supervision 38
8.4.3 Installation and control panel wiring (B450) 38
8.4.4 Diagnostic LEDs 39
8.5 Compatible receivers for IP communication 40
9
Keypads, keyswitches, keyfobs and transmitters 42
9.1 Keypads 42
9.1.1 Keypads overview 42
9.1.2 B921C Two-line Capacitive Keypad with Inputs 43
9.1.3 Shortcuts and custom functions 43
9.1.4 Address settings 44
9.1.5 Supervision 44
9.1.6 Installation and control panel wiring (keypads) 44
9.1.7 Sensor loops overview and wiring (B921C/B942/B942W only) 45
9.1.8 Output wiring (B942/B942W only) 46
9.1.9 Troubleshooting 46
9.2 Keyswitches 46
9.2.1 Operation 46
9.2.2 Installation and control panel wiring (keyswitches) 46
9.3 RADION keyfobs and Inovonics pendant transmitters 47
10
On-board outputs 49
10.1 Circuit protection 49
10.2 Total available power 49
10.3 Open collector outputs 50
11
Off-board outputs 51
11.1 B308 octo-output module 51
11.1.1 SDI2 address settings 51
11.1.2 Supervision 51
11.1.3 Installation and control panel wiring (B308) 52
12
On-board points 54
12.1 Point sensor loops 54
12.1.1 Single EOL (and no EOL) resistor circuit style 54
To Next Page
Loading...
Need help?
General
