Control Panels Table of contents | en 5
Bosch Security Systems, Inc. Installation Manual 2018.07 | 16 | F.01U.287.180
12.1.2 Dual EOL resistor circuit style 55
12.2 Point response time 56
13
Off-board points 57
13.1 B208 octo-input module 57
13.1.1 SDI2 address settings 57
13.1.2 Supervision 57
13.1.3 Installation and control panel wiring (B208) 57
13.1.4 Sensor loops overview and wiring 59
13.2 Off-board points test 61
13.3 Extra Point events 61
13.4 Missing point conditions 61
14
Wireless modules 62
14.1 B810 receiver 62
14.1.1 SDI2 address settings 62
14.1.2 Supervision 62
14.1.3 Installation and control panel wiring (B810) 62
14.2 B820 SDI2 Inovonics Interface Module 63
14.2.1 SDI2 address settings 63
14.2.2 Supervision 63
14.2.3 Installation and control panel wiring (B820) 63
15
Access control 65
15.1 B901 door controller 65
15.1.1 Address settings 65
15.1.2 Supervision 65
15.1.3 Installation and control panel wiring (B901) 65
15.2 Card reader wiring 66
16
Program and test the control panel 67
16.1 Program the control panel 67
16.1.1 Program the control panel with RPS 67
16.1.2 Program the control panel with the Installer Services Portal programming tool 68
16.1.3 Program the control panel with a keypad 68
16.2 Walk tests 68
16.2.1 Fire walk test 68
16.2.2 Intrusion walk test 69
16.2.3 Service walk test 69
16.2.4 Invisible walk test 70
17
Control panel board overview 71
18
System wiring diagrams 73
18.1 System wiring overview 73
18.2 Battery lead supervision wiring 74
18.3 2-wire smoke wiring (B201) 75
18.4 2-wire smoke wiring (D125B) 76
18.5 Notification appliance circuit wiring 76
18.6 SDI2 devices general system wiring 78
18.6.1 SDI2 bus wiring recommendations 78
18.7 Wiring label 81
19
Approved applications 82
19.1 Optional compatible equipment 82
19.1.1 Burglar applications 82
To Next Page
Loading...
Need help?
General
