SmartFlex
4.14 L2TP Tunnel Configuration
L2TP is an unencrypted protocol. L2TP via IPv6 is not supported.
To open the L2TP Tunnel Configuration page, click L2TP in the Configuration section of the
main menu. The L2TP tunnel function allows you to create a password protected connection
between 2 L AN networks. The router activates the tunnels after you mark the Create L2TP
tunnel check box.
Item Description
Mode Specifies the L2TP tunnel mode on the router side:
• L2TP server – Specify an IP address range offered by
the server.
• L2TP client – Specify the IP address of the server.
Server IP Address IP address of the server.
Client Start IP Address IP address to start with in the address range. The range is
of fered by the server to the clients.
Client End IP Address The last IP address in the address range. The range is offered
by the server to the clients.
Local IP Address IP address of the local side of the tunnel.
Remote IP Address IP address of the remote side of the tunnel.
Remote Subnet Address of the network behind the remote side of the tunnel.
Remote Subnet Mask The mask of the network behind the remote side of the tunnel.
Username Username for the L2TP tunnel login.
Password Password for the L2TP tunnel login.
Table 46: L2TP Tunnel Configuration
Figure 45: L2TP Tunnel Configuration
90
To Next Page
Loading...
Need help?
General