SmartFlex
4.6 WLAN Configuration
This item is available only if the router is equipped with a WiFi module.
The WiFi LAN and DHCP server page is displayed by selecting WLAN in the configuration
section. You will then be able to set the following properties (see table below). Use the Enable
WLAN interface check box at the top of this form to enable WiFi LAN interface.
WLAN Configuration page is divided into IPv4 and IPv6 columns. It is the independent
dual stack configuration of IPv4 and IPv6 protocols – you can configure either one of them or
both. Configuration items and IPv6 to IPv4 differences are described in the tables below.
Figure 28: WLAN Configuration
Item Description
Operating Mode WiFi operating mode:
• access point (AP) – The router becomes an access point
to which other devices in station (STA) mode can be con-
nected.
• station (STA) – Router becomes a client station. It will re-
ceive data packets from the available access point (AP) and
send data from cable connection via the WiFi network.
Continued on next page
58
To Next Page
Loading...