SmartFlex
If the parameter Data Limit State (see below) is set to not applicable or Send SMS when data
limit is exceeded in SMS Configuration is not selected, the Data Limit set here will be ignored.
4.3.6 Switch between SIM Cards Configuration
In the lower part of the configuration form you can specify the rules for toggling between
the two SIM cards.
The router will automatically toggle between the SIM cards and their individual setups depend-
ing on the configuration settings specified here (manual permission, roaming, data limit, binary
inputs state). Note that the SIM card selected for connection establishment is the result of the
logical product (AND) of the configuration here (table below).
Item Description
SIM Card Enable or disable the use of a SIM card. If you set all the SIM
cards to disabled, this means that the entire cellular module is
disabled.
• enabled – It is possible to use the SIM card.
• disabled – Never use the SIM card, the usage of this SIM
is forbidden.
Roaming State Configure the use of SIM cards based on roaming. This roaming
feature has to be activated for the SIM card on which it is enabled!
• not applicable – It is possible to use the SIM card every-
where.
• home network only – Only use the SIM card if roaming is
not detected.
Data Limit State Configure the use of SIM cards based on the Data Limit set
above:
• not applicable – It is possible to use the SIM regardless of
the limit.
• not exceeded – Use the SIM card only if the Data Limit (set
above) has not been exceeded.
Continued on next page
43
To Next Page
Loading...
Need help?
General