SmartFlex
4.15 PPTP Tunnel Configuration
PPTP is an unencrypted protocol. PPTP via IPv6 is not supported.
Select the PPTP item in the menu to configure a PPTP tunnel. PPTP tunnel allows pass-
word protected connections between two LANs. It is similar to L2TP. The tunnels are active
after selecting Create PPTP tunnel.
Item Description
Mode Specifies the L2TP tunnel mode on the router side:
• PPTP server – Specify an IP address range offered by
the server.
• PPTP client – Specify the IP address of the server.
Server IP Address IP address of the server.
Local IP Address IP address of the local side of the tunnel.
Remote IP Address IP address of the remote side of the tunnel.
Remote Subnet Address of the network behind the remote side of the tunnel.
Remote Subnet Mask The mask of the network behind the remote side of the tunnel
Username Username for the PPTP tunnel login.
Password Password for the PPTP tunnel login.
Table 48: PPTP Tunnel Configuration
The changes in settings will apply after pressing the Apply button.
Figure 47: PPTP Tunnel Configuration
The firmware also supports PPTP passthrough, which means that it is possible to create a
tunnel through the router.
92
To Next Page
Loading...