SmartFlex
4. Configuration
4.1 LAN Configuration
To enter the Local Area Network configuration, select the LAN menu item in the Config-
uration section. The LAN item will expand in the menu on the left, so you can choose the
proper Ethernet interface to configure: Primary LAN for the router’s first Ethernet interface
(ETH0), Secondary LAN for the router’s second Ethernet interface (ETH1) and Tertiary LAN
for the third Ethernet interface if the router has 3-port Ethernet SWITCH or RS232-RS485-ETH
interface.
LAN Configuration page is divided into IPv4 and IPv6 columns, see Figure 11. There is
dual stack support of IPv4 and IPv6 protocols – they can run alongside, you can configure
either one of them or both. If you configure both IPv4 and IPv6, other network devices will
choose the communication protocol. Configuration items and IPv6 to IPv4 differences are
described in the tables below.
Figure 11: LAN Configuration page
25
To Next Page
Loading...