B+B SmartWorx SmartFlex - Serial Gateway - Konﬁgurace Expansion Port 1

To Next Page

To Previous Page

SmartFlex

Figure 97: Serial Gateway – konﬁgurace Expansion Port 1

To communicate with the serial device (PLC), connect from the PC (Labeled as SCADA in

Fig. 96) as a TCP client to the IP address 10.0.6.238, port 2345 (the public IP address of the

SIM card used in the router, corresponding to the usb0 network interface). The devices can

now communicate. To check the connection, go to System Log (Status section) and look for

the TCP connection established message.

144