SmartFlex
Module name Description
MODBUS TCP2RTU Provides a conversion of MODBUS TCP/IP protocol to MDBUS
RTU protocol, which can be operated on the serial line.
Easy VPN client Provides secure connection of LAN network behind our router
with LAN network behind CISCO router.
NMAP Enables TCP and UDP scan.
Daily Reboot Enables daily reboot of the router at the specified time.
HTTP Authentication Adds the process of authentication to a server that doesn’t pro-
vide this service.
BGP, RIP, OSPF Adds support of dynamic protocols.
PIM SM Adds support of multicast routing protocol PIM-SM.
WMBUS Concentrator Enable the reception of messages from WMBUS meters and
saves contents of these messages to an XML file.
pduSMS Sends short messages (SMS) to specified number.
GPS Allows the router to provide location and time information in
all weather, anywhere on or near the Earth, where there is an
unobstructed line of sight to four or more GPS satellites.
Pinger Allows you to manually or automatically verify the functionality
of the connection between two network inter faces (ping).
IS-IS Adds support of IS-IS protocol.
Table 75: User modules
Attention: In some cases the firmware update can cause incompatibility with installed
user modules. Some of them are dependent on the version of the Linux kernel (for exam-
ple SmsBE and PoS Configuration). It is best to update user modules to the most recent
version.
Information about the user module and the firmware compatibility is at the beginning of the
user module’s Application Note.
126
To Next Page
Loading...
Need help?
General