B+B SmartWorx SmartFlex User Manual

SmartFlex
Figure 86: Access to the Internet from LAN – LAN configuration
Mobile WAN Configuration Use the Mobile WAN item in the Configuration section to con-
figure the connection to the mobile network. (Fig. 87.) In this case (depending on the SIM
card) the configuration form can be blank. But make sure that Create connection to mobile
network is checked (this is the factory default). For more details, see Chapter 4.3.1.
Figure 87: Access to the Internet from LAN – Mobile WAN configuration
To check whether the connection is working properly, go to the Mobile WAN item in the
Status section. You will see information about operator, signal strength etc. At the bottom,
you should see the message: Connection successfully established. The Network item should
display information about the newly created network interface, usb0 (mobile connection). You
should also see the IP address provided by the network operator, as well as the route table
etc. The LAN now has Internet access.
136

B+B SmartWorx SmartFlex Specifications

General

Brand	B+B SmartWorx
Model	SmartFlex
Category	Network Router
Language	English