SmartFlex
Item Description
Bridged Activates/deactivates the bridging function on the router.
• no – The bridging function is inactive (default).
• yes – The bridging function is active.
Media Type Specifies the type of duplex and speed used in the network.
• Auto-negation – The router automatically sets the best speed
and duplex mode of communication according to the network’s
possibilities.
• 100 Mbps Full Duplex – The router communicates at 100 Mbps,
in the full duplex mode.
• 100 Mbps Half Duplex – The router communicates at 100 Mbps,
in the half duplex mode.
• 10 Mbps Full Duplex – The router communicates at 10 Mbps, in
the full duplex mode.
• 10 Mbps Half Duplex – The router communicates at 10 Mbps, in
the half duplex mode.
PoE PSE
• enabled – The router provides power on the Ethernet cable.
• disabled – The router does not provide power on the Ethernet
cable (default).
Table 16: Configuration of the Network Interface – global items
4.1.1 DHCP Server
The DHCP server assigns the IP address, gateway IP address (IP address of the router)
and IP address of the DNS ser ver (IP address of the router) to the connected clients. If these
values are filled in by the user in the configuration form, they will be preferred.
The DHCP server supports static and dynamic assignment of IP addresses. Dynamic
DHCP assigns clients IP addresses from a defined address space. Static DHCP assigns IP
addresses that correspond to the MAC addresses of connected clients.
If IPv6 column is filled in, the DHCPv6 server is used. DHCPv6 server offers stateful ad-
dress configuration to connected clients. Only when the Subnet Prefix above is set to 64,
the DHCPv6 server offers both – the stateful address configuration and SLAAC (Stateless
Address Autoconfiguration).
27
To Next Page
Loading...
Need help?
General