SmartFlex
4.16 Services
4.16.1 DynDNS
The DynDNS function allows you to access the router remotely using an easy to remem-
ber custom hostname. This DynDNS client monitors the IP address of the router and up-
dates the address whenever it changes. In order for DynDNS to function, you require a pub-
lic IP address, either static or dynamic, and an active Remote Access service account at
www.dyndns.org. Register the custom domain (third-level) and account information specified
in the configuration form. You can use other ser vices, too – see the table below, Server item.
To open the DynDNS Configuration page, click DynDNS in the main menu.
Item Description
Hostname The third order domain registered on the www.dyndns.org server.
Username Username for logging into the DynDNS server.
Password Password for logging into the DynDNS server.
Server Specifies a DynDNS ser vice other than the www.dyndns.org. Possible
other services: www.spdns.de, www.dnsdynamic.org, www.noip.com
Enter the update server service information in this field. If you leave this
field blank, the default server members.dyndns.org will be used.
IP Mode Specifies the version of IP protocol:
• IPv4 – IPv4 protocol is used only (default).
• IPv6 – IPv6 protocol is used only.
• IPv4/IPv6 – IPv4 and IPv6 dual stack is enabled.
Table 50: DynDNS Configuration
Example of the DynDNS client configuration with the domain company.dyndns.org:
Figure 49: DynDNS Configuration Example
To access the router’s configuration remotely, you will need to have enabled this option in the
NAT configuration (bottom part of the form), see chapter 4.10.
94
To Next Page
Loading...
Need help?
General