SmartFlex
Continued from previous page
Item Description
BIN0 State Configure the use of SIM cards based on binary input 0 state:
• not applicable – It is possible to use the SIM regardless of
BIN0 state.
• on – Only use the SIM card if the BIN0 state is logical 0 –
voltage present.
• off – Only use the SIM card if the BIN0 state is logical 1 –
no voltage.
BIN1 State Configure the use of SIM cards based on binary input 1 state:
• not applicable – It is possible to use the SIM regardless of
BIN1 state.
• on – Only use the SIM card if the BIN1 state is logical 0 –
voltage present.
• off – Only use the SIM card if the BIN1 state is logical 1 –
no voltage.
Table 26: Switch between SIM cards configuration
Use the following parameters to specify the decision making of SIM card switching in the
cellular module.
Item Description
Default SIM Card Specifies the modules’ default SIM card. The router will attempt
to establish a connection to mobile network using this default.
• 1st – The 1st SIM card is the default.
• 2nd – The 2nd SIM card is the default.
Initial State Specifies the action of the cellular module after the SIM card has
been selected.
• online – establish connection to the mobile network after
the SIM card has been selected (default).
• offline – go to the off-line mode after the SIM card has been
selected.
Note: If offline, you can change this initial state by SMS message
only – see SMS Configuration. The cellular module will also go
into of f-line mode if none of the SIM cards are not selected.
Continued on next page
44
To Next Page
Loading...
Need help?
General