SmartFlex
Continued from previous page
Item Description
Client Isolation In access point (AP) mode only. If checked, the access point will
isolate every connected client so they do not see each other (they
are in different networks, they cannot PING between each other). If
unchecked, the access point behavior is like a switch, but wireless
– the clients are in the same LAN and can see each other.
Country Code Code of the country where the router is installed. This code must be
entered in ISO 3166-1 alpha-2 format. If a country code isn’t speci-
fied and the router has not implemented a system to determine this
code, it will use "US" as the default country code.
If no country code is specified or if the wrong country code is en-
tered, the router may violate country-specific regulations for the use
of WiFi frequency bands.
This option is not available on SmartFlex SR305 routers – the
"US" country code is set by default on these versions of router.
HW Mode HW mode of WiFi standard that will be supported by WiFi access
point.
• IEE 802.11b (2.4 GHz)
• IEE 802.11b+g (2.4 GHz)
• IEE 802.11b+g+n (2.4 GHz)
• IEE 802.11a (5 GHz)
• IEE 802.11a+n (5 GHz)
Channel The channel, where the WiFi AP is transmitting.
Supported 2.4 GHz channels: 1, 2, 3, 4, 5, 6, 7, 8, 9, 10, 11, 12, 13.
On SmartFlex SR305 routers only channels 1 to 11 are supported!
Supported 5 GHz channels: 36, 40, 44, 48, 52, 56, 60, 64, 149,
153, 157, 161, 165.
BW 40 MHz The option for HW mode 802.11n which allows transmission on two
standard 20 MHz channels simultaneously. The option is also avail-
able in the STA mode and it has to be enabled in both the AP and
the STA mode if using the high throughput mode.
WMM Basic QoS for WiFi networks is enabled by checking this item. This
version doesn’t guarantee network throughput. It is suitable for sim-
ple applications that require QoS.
Continued on next page
52
To Next Page
Loading...
Need help?
General