ST-20A smart transmitter ( software setup)
ST-20A smart transmitter ( DIP switches setup )
5-33 PROG Code
*B36: Display Symbol and Description of MODE
SP1, SEL1 SEL5 are unlocked
Lock all parameters except SP1
All parameters are locked
5-34 Mode
*C: The Parameters are pre-set with the default values specified in the table.
*E: The unit PV means that the unit of parameter is the same as the unit of PV (process value).The unit of
PV is determined by PVMD, IN1, IN2, IN1U, and IN2U.
*E1: Unit determination for A1SP, A1DV and A1HY
Range of A1SP same as range of
P1.2.H,P1.2.L,D1.2.H,D1.2.L
5-35 Unit Determination for A1SP, A1DV, A1HY
*E2: Unit determination for A2SP, A2DV and A2HY
Range of A2SP same as range of
P1.2.H,P1.2.L,D1.2.H,D1.2.L
5-36 Unit Determination for A2SP, A2DV, A2HY
*E3: Unit determination for Ramp
5-37 Ramp Unit
*E4: Unit determination for AOLO and AOHI