3-97
Confidential
(9) Remove the Power cord from the Power cord holder.
(10)Remove the three screws (TAPTITE CUP S M3x6) and remove the Power supply
PCB ASSY from the Lower power supply frame.
(11)Disconnect the Connector from the Power supply PCB ASSY.
Fig. 3-113
Harness routing: Refer to " Main PCB ASSY and MJ PCB ASSY",
" Lower cover (Left side)"," Power supply PCB ASSY"
TAPTITE CUP S M3x6
TAPTITE CUP S M3x6
Power cord
Power supply
Lower power supply
PCB ASSY
Connector
Power cord holder
Power supply harness
Insulation film (2 sheets)
frame
2
12 13