Index
94/108 CLS Pro 600 – Line and Contrast Sensor
Storage............................................................. 6
Operating modes
Automatic ...................................................... 49
Manual mode................................................. 49
Servo Center Position .................................... 49
Operating Principle.........................................10
Operation..................................................45, 51
P
Parameters of th main menu
Parameter - Line Width Tolerance................. 74
Parameters of the main menu
Configuration - Commander .......................... 61
Configuration - Edit Menu Configuration....... 68
Configuration - Mounting Position ................ 67
Configuration - Remote Control EKR.............. 65
Configuration - Sensor ................................... 62
Display............................................................ 76
Parameter ...................................................... 68
Parameter - Adaption Settings....................... 72
Parameter - Contrast Detection..................... 69
Parameter - Contrast Tracking....................... 70
Parameter - Destination................................. 69
Parameter - Illumination................................ 68
Parameter - Jobs ............................................ 68
Parameter - Plausibility Check ....................... 70
Parameter - Position Averaging ..................... 74
Parameter - Recapture Factor ....................... 75
Parameter - Web Stop Detection................... 75
Remote Control EKR....................................... 75
System Info .................................................... 77
Parameters of then main menu
Parameter - Splice Misalignment................... 74
Plug assignment..............................................88
Potential Explosive Areas..................................9
R
Remote control
Move the guiding device................................ 50
Move the set point......................................... 50
S
Safety Information......................................8, 17
Saving a job.....................................................57
SC Mode..........................................................49
Search Area.....................................................14
Selecting a job.................................................57
Sensor
Analogue output ............................................ 84
Control panel interface.................................. 85
Digital inputs.................................................. 84
Digital outputs ............................................... 84
Dismantling the BST eltromat holder............. 25
Enclosure socket ............................................ 35
Environmental conditions.............................. 84
Installation ..................................................... 20
Installation with BST eltromat holder............ 20
Installation with holder supplied by the cus-
tomer........................................................ 21
LEDs................................................................ 36
Maintenance.................................................. 90
Measuring window cover............................... 85
Power supply ................................................. 84
Service indicator displays............................... 36
Setting the device address............................. 78
Setting the gap to the scanning roller............ 22
Structure .......................................................... 9
Technical data................................................ 84
Terminator resistor........................................ 80
Weight ........................................................... 85
Set Position.....................................................13
Setting up quick menus ..................................59
Setup...............................................................51
Activating setup ............................................. 51
Area tracking.................................................. 55
Edge mode ..................................................... 52
Line mode ...................................................... 55
Standard......................................................... 54
Setup administration
Delete setup................................................... 61
Load setup...................................................... 60
Save setup...................................................... 60
Space requirement .........................................86
Status bar..................................................15, 48
Storage............................................................91
System
Standard operation........................................ 51
T
Target group .....................................................6
Technical data...........................................84, 85
Termninator resistors .....................................80
Terms Used in this Manual .............................12
Transport ........................................................91
To Next Page
Loading...
Need help?
General
