6-2-17 Scan Time
Definition :
1. The duration from user’s action to the next operation step of barcode
scanner. ( E.g. Default setting : 10 Secs. To switch the operation mode,
hold “Scan” key for 10 seconds, and LED light will start blinking. )
2. The time required to shut down scanning light when no barcode is
scanned.
*2QL+*
Configuration Range Unit Default Setting
1 ~ 30 Secs 1 Sec 10 Secs
Procedure
(A) Scan “Enter” barcode
(B) Scan “Scan Time” barcode
(C) Scan parameters from Hexadecimal / Decimal table
(D) Scan “OK“ barcode
(E) Scan “End” barcode
6-2-17 Scan Time
To Next Page
Loading...
