Enter 175 End
*/$%ENTR* *ZEND*
7. General Configuration Setting
7-2-6-5 ACK Timeout
To set up the period of time to receive ACK after sending data
*3C9+*
Procedure: Example:
(A) Scan “Enter” barcode
(B) Scan “ACK Timeout” barcode
(C) Scan parameters from
Hexadecimal / Decimal table
(D) Scan “OK“ barcode
(E) Scan “End” barcode
If configuration is.2 sec, the
parameter value is 2 sec / 1 sec = 2
7-2-6-6 Transmission Timeout
After sending the information, how long time did not respond will start timeout
*5CB+*
Configuration Range Unit Default Setting
2 ~ 255 secs 1 sec 3 secs
Configuration Range Unit Default Setting
2 ~ 255 secs 1 sec 3 secs
Procedure: Example:
(A) Scan “Enter” barcode
(B) Scan “Transmission Timeout”
barcode
(C) Scan parameters from
Hexadecimal / Decimal table
(D) Scan “OK“ barcode
(E) Scan “End” barcode
If configuration is.2 sec, the
parameter value is 2 sec / 1 sec = 2
To Next Page
Loading...
