Enter 145 End
*/$%ENTR* *ZEND*
7. General Configuration Setting
7-1-3 Enter ISP Mode
For software configuration, User must connect the scanner with PC via USB
cable, and scan “Enter “, “ISP” to enter the ISP mode. (PC might request for
Driver installation, please find the driver file “C0801b.inf ” in the CD)
*ZISP*
Procedure:
(1) Scan “Enter” Barcode
(2) Scan “ISP” barcode
7-1-4 Barcode Default
Scan the below barcode to restore the symbologies to the default settings.
*ZDEF*
Procedure:
(1) Scan “Enter” Barcode
(2) Scan “Barcode Default” barcode
7-1-5 All Default
Configuration setting to restored to factory default setting.
*ZADE*
Procedure:
(1) Scan “Enter” Barcode
(2) Scan “All Default” barcode
7-1-4 Barcode Default
7-1-5 All Default
7-1-3 Enter ISP Mode
To Next Page
Loading...
