Canmax CM-2D601 - Bluetooth Parameter Configuration by User Manual; BT Local Name

43
4. Memory / Bluetooth Mode
4-2-5 Bluetooth parameter configuration by user manual
4-2-5-1 BT Local name
For Slave, Master, HID Dongle, iOS Device Mode
This option enables to assign Bluetooth the scanner name. Please refer to the
HEX ASCII table (Form 0~9, A~F). The first digit and last digit cannot be space
or “-“. If scanner name setting is incorrect, connection failure will occur.
Configuration Max. Configurable Length Default Setting
Please refer to
ASCII table
16 digits ‘SmartBt’
Procedure:
(1) Enter: (Enter setting) */$%ENTR*
(2) “BT Local name” *G5S+*
(3) Scan Hexadecimal/Decimal Barcode table for input parameters.
(4) OK : (Selection confirmed) *%OK*
(5) End: (Exit setting) *ZEND*
Example:
Set Local name as ‘BT Scanner’
(A) Scan “Enter” barcode
(B) Scan “BT Local Name” barcode
(C) Scan parameters from Hexadecimal / Decimal barcode table =>“4”,”2”,
“5”,”4”, “2”,”0”, “5”,”3”, “6”,”3”, “6”,”1”, “6”,”E”, “6”,”E”, “6”,”5”, “7”,”2”,”OK”
(configured as ‘BT Scanner’, Please refer to ASCII TABLE)
(D) Scan “End” Barcode
4-2-5 Bluetooth parameter configuration by user manual