Enter 150 End
*/$%ENTR* *ZEND*
7. General Configuration Setting
7-2-1-5 Transmission Char Delay
After setting the number of characters sent into the Delay time
*37W+*
7-2-1-6 Transmission Char Gap Time
To set up the length of Delay time between character
*47X+*
Procedure: Example:
(A) Scan “Enter” barcode
(B) Scan “Transmission Char Gap
Time” barcode
(C) Scan parameters from
Hexadecimal / Decimal table
(D) Scan “OK“ barcode
(E) Scan “End” barcode
If configuration is 2 ms, the
parameter value is 2 ms / 1 ms = 2
Configuration Range Default Setting
0 ~ 255 0
Procedure
(A) Scan “Enter” barcode
(B) Scan “Transmission Char Delay” barcode
(C) Scan parameters from Hexadecimal / Decimal table
(D) Scan “OK“ barcode
(E) Scan “End” barcode
Configuration Range Unit Default Setting
0 ~ 255 ms 1 ms 0 ms
To Next Page
Loading...
