Enter 307 End
*/$%ENTR* *ZEND*
8. Symbology Settings
8-19-5 DblConFirm
To decode the barcode multiple times. If the result of each decoding is the same, it
means that the barcode decoding is successful
*JYS+*
Procedure:
(A) Scan “Enter” barcode
(B) Scan “DblConFirm” barcode
(C) Scan parameters from Hexadecimal / Decimal table
(D) Scan “OK“ barcode
(E) Scan “End” barcode
8-19-6 TruncateLeading
To set up the number of digits to be omitted from the beginning of the barcode
*K1Q+*
Procedure:
(A) Scan “Enter” barcode
(B) Scan “TruncateLeading” barcode
(C) Scan parameters from Hexadecimal / Decimal table
(D) Scan “OK“ barcode
(E) Scan “End” barcode
Configuration Range Default Setting
0~10 0
Configuration Range Default Setting
0~80 0
8-19-5 DblConFirm
8-19-6 TruncateLeading
To Next Page
Loading...
