Canmax CM-2D601 - Mode Switch

Enter 146 End
*/$%ENTR* *ZEND*
7. General Configuration Setting
7-1-6 Mode Switch
After reading ENTER label, scan the below appropriate barcode to switch to
the desired operation mode.
To Cable Mode
*ZTOS*
To Memory Mode
*ZTOM*
To BT Mode
*ZTOB*
Procedure:
(1) Scan “Enter” Barcode
(2) Scan “To Cable Mode” or “To Memory Mode” or “To BT Mode” barcode
7-1-6 Mode Switch