Canmax CM-2D601 - Transmission Char Gap Time

Enter 161 End
*/$%ENTR* *ZEND*
7. General Configuration Setting
7-2-3-7 Transmission Char Gap Time
To set up the length of Delay time between character
*7F1+*
Procedure: Example:
(A) Scan “Enter” barcode
(B) Scan “Transmission Char Gap
Time” barcode
(C) Scan parameters from
Hexadecimal / Decimal table
(D) Scan “OK“ barcode
(E) Scan “End” barcode
If configuration is 2 ms, the
parameter value is 2 ms / 1 ms = 2
7-2-3-8 Transmission Record Gap Time
This function can set Delay Time between 2 records.
*8F2+*
Procedure: Example:
(A) Scan “Enter” barcode
(B) Scan “Transmission Record Gap
Time” barcode
(C) Scan parameters from
Hexadecimal / Decimal table
(D) Scan “OK“ barcode
(E) Scan “End” barcode
If configuration is 200 ms, the
parameter value is 200ms / 10ms =
20
Configuration Range Unit Default Setting
0 ~ 255 ms 1ms 0 ms
Configuration Range Unit Default Setting
0 ~ 2550 ms 10 ms 0 ms