Canmax CM-2D601 - Event Vibrator

Enter 80 End
*/$%ENTR* *ZEND*
6. Memory / Bluetooth / Cable General Setting
6-1-15 Event Vibrator
Mode Event Vibrator is used to give a vibration signal whenever certain
operations, such as switching operation modes, entering data transmission
mode, and deleting all saved barcodes, are initiated by using Scan Button or
Small Trigger. Scan the appropriate barcode to enable or disable Mode Event
Vibrator.
*7LM0*
Disable
*7LM1*
Enable
6-1-16 Warning Vibrator
Scan the appropriate barcode to enable or disable Warning Vibrator when an
error occurs .
*0LO0*
Disable
*0LO1*
Enable
6-1-15 Event Vibrator
6-1-16 Warning Vibrator