Canmax CM-2D601 - Host Interface; Version; Abort Setting

Enter 144 End
*/$%ENTR* *ZEND*
7. General Configuration Setting
7-1 Host Interface
7-1-1 Version
Firmware information listing, the scanner firmware information included the
ISP Version, the firmware version,2D Engine Version and Bluetooth module
version (if scanner Bluetooth function is available).
*ZVER*
Procedure:
(1) Scan “Enter” Barcode
(2) Scan “Version” barcode
Note: Firmware version listing as below
Isp: 0001.0000  ISP version
Kernel: 0001.0000  Firmware version
2D Eng: CZ000052BAA  2D Engine version.
Bt: V100-T028BT-20111027  Bluetooth module version (this is only
available for Bluetooth model).
7-1-2 Abort Setting
To skip or cancel current operation, your current settings will be aborted before
you scan “END” barcode to finish programming.
*ZEXT*
Procedure:
(1) Scan “Enter” Barcode
(2) Scan “Abort” barcode
Scan “Abort” Barcode to cancel the setting before you scan “END”
barcode
7. General Configuration Setting
7-1 Host Interface
7-1-1 Version
7-1-2 Abort Setting