Enter 292 End
*/$%ENTR* *ZEND*
8. Symbology Settings
8-17-7 DblConFirm
To decode the barcode multiple times. If the result of each decoding is the same, it
means that the barcode decoding is successful
*QY8+*
Procedure:
(A) Scan “Enter” barcode
(B) Scan “DblConFirm” barcode
(C) Scan parameters from Hexadecimal / Decimal table
(D) Scan “OK“ barcode
(E) Scan “End” barcode
8-17-8 ConcatenationTimeOut
When searching for bar codes during concatenation, you may wish to set a
delay used to find the next bar code. Set the length (in milliseconds) for this
delay by scanning the following bar code.
*IY9+*
Procedure:
(A) Scan “Enter” barcode
(B) Scan “ConcatenationTimeOut” barcode
(C) Scan parameters from Hexadecimal / Decimal table
(D) Scan “OK“ barcode
(E) Scan “End” barcode
Configuration Range Default Setting
0~10 0
Configuration Range Unit Default Setting
10~4000 ms 1ms 800 ms
8-17-7 DblConFirm
8-17-8 ConcatenationTimeOut
To Next Page
Loading...
