Canmax CM-2D601 - Erase Barcode Data (Single Data; All Data)

36
4. Memory / Bluetooth Mode
2) Connect the USB cable between scanner and PC, and scan the below
barcode.
(1).Enter: (Enter setting) */$%ENTR*
(2).Send Data *ZMTX*
4-1-3 Erase barcode data (single data/ all data)
Erase single data:
While holding Small Trigger and point to the scanned barcode, this action
will erase the last previous saved barcode data in the memory.
Erase all data:
1. While holding Small Trigger till Orange LED turns rapidly blinking,
2. Press down Scan Button
3. Release Scan Button and Small Trigger together, alll barcode data
saved in the memory will be erased.
OR
By scanning the below barcode:
(1).Enter: (Enter setting) */$%ENTR*
(2).Clear Data *ZFCA*
Caution: Scan the “Clear Data” Barcode will erase all the barcode data
saved in the memory; make sure you have back up all the barcode data
before performing this action.
4-1-3 Erase barcode data (Single data / All data)