Enter 174 End
*/$%ENTR* *ZEND*
7. General Configuration Setting
7-2-6-3 <CMD> & <BAR> Characters
Scan the appropriate barcode to enable or disable <BAR> and <CMD> escape
characters
*2BR0*
Disable
*2BR1*
Enable
7-2-6-4 Retransmission Count
To avoid data transmission loss, messages sometimes have to be resent due
to a failure to receive ACK signal; When the amount of resending is out of
range and STILL not yet received ACK, which means Timeout
*2C8+*
Procedure:
(A) Scan “Enter” barcode
(B) Scan “Retransmission Count” barcode
(C) Scan parameters from Hexadecimal / Decimal table
(D) Scan “OK“ barcode
(E) Scan “End” barcode
Configuration Range Default Setting
0 ~ 255 2
To Next Page
Loading...
