Canmax CM-2D601 - Setup Timeout Time; STX Escape Characters

Enter 187 End
*/$%ENTR* *ZEND*
7. General Configuration Setting
7-3-21 STX Escape Characters
Set Stx digits
*74L+*
Configuration Length
Default Setting
1 0x02
Procedure:
(A) Scan “Enter” barcode
(B) Scan “STX Escape Characters” barcode
(C) Scan parameters from Hexadecimal / Decimal table
(D) Scan “OK“ barcode
(E) Scan “End” barcode
7-3-22 Setup Timeout Time
Set when after enter into setting mode, it is Timeout if there is no action within a
period of time.
*75B+*
Procedure: Example:
(A) Scan “Enter” barcode
(B) Scan “Setup Timeout Time”
barcode
(C) Scan parameters from
Hexadecimal / Decimal table
(D) Scan “OK“ barcode
(E) Scan “End” barcode
If configuration is 2 minutes, the
parameter value is 2 minutes / 1 sec
= 120
Configuration Range Unit Default Setting
1~255 Secs 1 Sec 60 Secs
7-3-21 STX Escape Characters
7-3-22 Setup Timeout Time