Canmax CM-2D601 - Truncateending

Enter 331 End
*/$%ENTR* *ZEND*
8. Symbology Settings
8-23-5 TruncateEnding
To set up the number of digit to be omitted from the end of the barcode
*O4I+*
Procedure:
(A) Scan “Enter” barcode
(B) Scan “TruncateEnding” barcode
(C) Scan parameters from Hexadecimal / Decimal table
(D) Scan “OK“ barcode
(E) Scan “End” barcode
8-23-6 TruncateZero
Whether to omit 0 from the beginning of the barcode
*Q4K0*
Disable
*Q4K1*
Enable
Configuration Range Default Setting
0~80 0
8-23-5 TruncateEnding
8-23-6 TruncateZero