Canmax CM-2D601 - Date;Time Position

Enter 92 End
*/$%ENTR* *ZEND*
6. Memory / Bluetooth / Cable General Setting
6-1-38 Date/Time Position
If you want to display data from Memory, you can use this function to set
Date/Time position. “Date & Time Transmission” must be enabled and
configure the following formats:.
*7WB0*
Before
*7WB1*
After
6-1-39 DateTimeSpareChar
Set separated symbol to distinguish date and time
*3WP+*
6-1-40 Reject Same
Whether it needs to activate excluding the same code.
*4WH0*
Disable
*4WH1*
Enable
Configuration Length
Default Setting
1 “ “
Procedure
(A) Scan “Enter” barcode
(B) Scan “DateTimeSpareChar” barcode
(C) Scan parameters from Hexadecimal / Decimal table
(D) Scan “OK“ barcode
(E) Scan “End” barcode
6-1-38 Date/Time Position
6-1-39 DateTimeSpareChar
6-1-40 Reject Same