Canmax CM-2D601 - Good Read Beep Time

Enter 122 End
*/$%ENTR* *ZEND*
6. Memory / Bluetooth / Cable General Setting
6-3-15 Good Read Beep Time
When decoding successfully, it will make a sound, you can use this setting to
set the duration of Beep Time.
*7IP+*
Configuration Range
Unit Default Setting
10 ~ 2550ms 10ms 100 ms
6-3-16 Good Read Vibrator time
Please follow the below steps to specify vibrator duration when a barcode is decoded
successfully.
*8IQ+*
Configuration Range Unit Default Setting
10 ~ 2550 ms 10 ms 50 ms
Procedure
(A) Scan “Enter” barcode
(B) Scan “Good Read Beep Time” barcode
(C) Scan parameters from Hexadecimal / Decimal table
(D) Scan “OK“ barcode
(E) Scan “End” barcode
Procedure
(A) Scan “Enter” barcode
(B) Scan “Good Read Vibrator time” barcode
(C) Scan parameters from Hexadecimal / Decimal table
(D) Scan “OK“ barcode
(E) Scan “End” barcode
6-3-15 Good Read Beep Time
6-3-16 Good Read Vibrator time