Canmax CM-2D601 - Page 121

Enter 121 End
*/$%ENTR* *ZEND*
6. Memory / Bluetooth / Cable General Setting
6-3-13 Power on light
On Cable mode, when the scanner is on, whether to turn on the scanning light
automatically.
*5I50*
Disable
*5I51*
Enable
6-3-14 Good Read Beep Freq
When decoding successfully, it will make a sound, and you can use this setting
to set Beep Frequency.
*6IO+*
Configuration Range
Unit Default Setting
100 ~ 3500Hz 100Hz 2700 Hz
Procedure
(A) Scan “Enter” barcode
(B) Scan “Good Read Beep Freq” barcode
(C) Scan parameters from Hexadecimal / Decimal table
(D) Scan “OK“ barcode
(E) Scan “End” barcode
6-3-13 Power on light
6-3-14 Good Read Beep Freq