Enter 143 End
*/$%ENTR* *ZEND*
7. General Configuration Setting
7-2-6-5 ACK Timeout
7-2-6-6 Transmission Timeout
7-2-6-7 Transmission Char Delay
7-2-6-8 Transmission Char Gap Time
7-2-6-9 Transmission Record Gap Time
7-3 System Control
7-3-1 Mode
7-3-2 System Beep Volume
7-3-3 DcPlug Cable Mode
7-3-4 Date format
7-3-5 Time format
7-3-6 System Virbator
7-3-7 Show Header Str
7-3-8 Show Footer Str
7-3-9 Show Header SerNum
7-3-10 Show Footer SerNum
7-3-11 Show Header Date & Time
7-3-12 Show Footer Date & Time
7-3-13 Show Header RecCnt
7-3-14 Show Footer RecCnt
7-3-15 Date Separator
7-3-16 Time Separator
7-3-17 DLE Escape Characters
7-3-18 CMD Escape Characters
7-3-19 BAR Escape Characters
7-3-20 ETX Escape Characters
7-3-21 STX Escape Characters
7-3-22 Setup Timeout Time
7-3-23 Set Date & Time
7-3-24 All Memory Data Clear
7-3-25 All Memory Data Transmission
7-3-26 Footer Chatacters
7-3-27 Header Chatacters
Note: It is recommended to print out the Hexadecimal /
Decimal table (page: 377) for parameter setting.
To Next Page
Loading...
