Handling rolls
Manual (when using media that cannot be cut with the Cutter Unit )
1. On the T ab Selection screen of the Control Panel , press ◄ or ► to select the Paper tab ( ).
Note
• If the T ab Selection screen is not displayed, press the Menu button.
2. Press the OK button. The Paper Menu is displayed.
3. Press ▲ or ▼ to select Paper Details , and then press the OK button.
4. Press ▲ or ▼ to select the type of paper , and then press the OK button.
5. Press ▲ or ▼ to select Cutting Mode , and then press the OK button.
6. Press ▲ or ▼ to select Manual , and then press the OK button.
7. Starts printing.
The printer stops advancing the paper after printing.
8. Press the Feed button.
Roll paper is fed to the specied cut position and then automatically stopped.
9. Cut the roll paper manually with scissors or the like.
Handling Paper 131
To Next Page
Loading...
