Canon Laser Class 810 - Page 346

Machine Settings
12-16
TX/RX SETTINGS
3. AUTO REDIAL Sets whether to redial automatically when the other line is busy
or a transmission error occurs. (See Reference Guide > Send/
Receive.)
ON Customizes the redial operation.
1. REDIAL TIMES Sets the number of retries. (1TIMES–10TIMES)
2. REDIAL
INTERVAL
Sets period of time before redialing. (2MIN.–99MIN.)
3. TX ERROR
REDIAL
Sets whether the machine redials automatically when
transmission error occurs.
ON
OFF
–
–
OFF After the first attempt at dialing fails, redialing is not attempted.
4. TIME OUT Sets whether to scan a document automatically after specifying
the destination.
* This function is not available when you dial with the numeric keys.
OFF
ON
–
–
5. STAMP DOCUMENT Sets whether to stamp documents when sending with Direct TX
or Memory TX, or to stamp documents only when sending with
Direct TX.
If you are using the LASER CLASS 830i, this setting is enabled
when sending to a fax, I-fax, e-mail, or file server destination.
DIRECT&MEMORY TX
DIRECT TX
–
–
6. DIALING LINE CHCK Sets whether to check the telephone line condition.
OFF
ON
–
–
4. RX SETTINGS Sets the reception features.
1. ECM RX Sets whether the ECM (Error Correction Mode) reception is
activated.
ON
OFF
–
–