Canon Laser Class 810 - Page 347

12-17
Machine Settings
TX/RX SETTINGS
2. FAX/TEL OPT. SET Sets the optional items in the <FaxTel> mode. (See Reference
Guide > Send/Receive.)
1. RING START TIME Sets the time the machine takes to check whether a call is a fax
or a voice call. (0SEC–30SEC)
2. F/T RING TIME Selects the ring length for voice calls. (15SEC–300SEC)
3. F/T SWITCH
ACTION
Selects whether the machine switches to the receive mode after
the ring time has elapsed, or whether if disconnects the call.
RECEIVE
DISCONNECT
–
–
3. DRPD:SELECT FAX Selects the ring pattern for fax calls.
DOUBLE RING
SHORT-SHORT-LONG
SHORT-LONG-SHORT
OTHER RING TYPE
NORMAL RING
–
–
–
–
–
4. INCOMING RING Sets whether the external telephone rings when the machine
receives a fax. This function is only available when the <RX
MODE> is set to <FaxOnly> or <FaxTel>.
ON The telephone rings when the machine receives a fax if an
external telephone is connected.
RING COUNT Sets the number of incoming rings before the machine answers.
(1TIMES–99TIMES)
OFF The telephone does not ring when the machine receives a fax.
(In the Sleep mode, the telephone may ring one or two times.)
5. REMOTE RX Sets whether to use remote receiving. This function is not
available when <ENERGY IN SLEEP> in <COMMON SETTINGS> is
set to <LOW>. (See Reference Guide > Send/Receive.)
ON The machine enables remote receiving.
REMOTE RX ID You can dial a code on remote extension to start receiving a
document.
A combination of two characters using 0 to 9, * and # is possible.
OFF The machine disables remote receiving.