Machine Settings
12-40
SYSTEM SETTINGS
2. STATELESS ADD SET Sets whether to automatically specify a stateless address upon
startup.
OFF
ON
–
–
3. MANUAL ADD SET Allocates an IPv6 address to the machine manually.
1. USE MANUAL
ADD
Sets whether to set a fixed IPv6 address to the machine.
OFF A fixed IPv6 address is not set.
ON Sets a fixed IPv6 address to the machine.
2. MANUAL
ADDRESS
Registers a fixed IPv6 address to the machine.
3. PREFIX LENGTH Sets the prefix length of the IPv6 address. (0-128)
4. DEF. ROUTER
ADD
Sets the default router address.
4. USE DHCPv6 Sets whether to set to obtain a stateful address from a DHCP
server using DHCPv6.
ON
OFF
–
–
5. PING COMMAND Enables you to check whether the machine can connect to a
device on the network.
1. PING
COMMAND
Enter the IPv6 address of a device on the network and press
[OK] to check whether the machine can connect to that device.
2. HOST NAME Enter the host name of a device on the network and press [OK]
to check whether the machine can connect to that device.
6. SET IP ADD RANGE Sets whether to restrict the range of IP addresses.
OFF Disables restriction of IP address of computers.
ON Enables you to set which IP addresses can send data (print/fax
jobs) to the machine. You can select to permit or reject up to
ten ranges of IP addresses. Set each range of IP addresses by
entering an IP address in both <START IP ADDRESS>, <END IP
ADDRESS> and <PREFIX LENGTH>.
1. IP ADDRESS 1
2. IP ADDRESS 2
3. IP ADDRESS 3
4. IP ADDRESS 4
5. IP ADDRESS 5
6. IP ADDRESS 6
7. IP ADDRESS 7
8. IP ADDRESS 8
9. IP ADDRESS 9
10. IP ADDRESS 10
–
–
–
–
–
–
–
–
–
–
To Next Page
