CEM liberty - Copying and Modifying an Existing Cycle

Liberty
™
Automated Microwave Peptide Synthesizer
600178 • Revision 5 • October 2009
31
Copying and Modifying an Existing Cycle
Often, it is easier to copy and modify an existing cycle rather that creating an entirely new cycle.
Cycles can easily be duplicated and modied within the Cycle Editor, and then they can be
moved to different scale folders as needed. To copy an existing cycle:
Open the folder of the appropriate method type, then open the subfolder for the 1.
appropriate scale if necessary.
Right click on a cycle and select Copy Cycle.2.
The new cycle will appear named “Copy of [cycle name]”. Type a new name and 3.
press Enter.
Any setting can be changed. Steps may be added or deleted as necessary using 4.
the Add Step and Delete Step buttons.
When all changes have been made, click Save to save the modied cycle.5.
If the new cycle is to be used at a different synthetic scale, drag the cycle from 6.
the folder it was created in to the appropriate folder.
NOTE
When copying a cycle to use with a different scale, verify that the volumes
used are appropriate for the new scale before using the cycle.