29. Removal of the harness butt jointed with the left-rear door
harness.
29.1. Disassemble the left B-pillar inner shield. (See Removal and
Installation of B-pillar Inner Shield)
29.2. Push down the plastic clips that fixes the harness connector
butt jointed left-rear door harness, and then unplug the harness plug
that butt joints the left-rear door harness.
30. Removal of the Interior and right-rear door butt jointed harness
30.1. Disassemble the right B-pillar inner shield. (See Removal and
Installation of B-pillar Inner Shield)
30.2. Unplug the harness plug butt jointed with the interior and
right-rear door.
31. Disassemble the ground wire.
32. Disassemble the screws that fix the BCM module, and then
disassemble the ground wire.
33. Use a cross head screwdriver to remove the left vehicle ceiling
handle, and then disassemble the ground wire.
To Next Page
Loading...
