Chroma 11210 - Page 134

Battery Cell Insulation Tester 11210 User’s Manual
10-18
SYSTem:HANDler:BEFOre:ACQ
It sets or queries Handler Fail signal state before ACQ activating.
Set command format: SYSTem:HANDler:BEFOre:ACQ {<NR1>}
Parameter: <NR1>, 0 and 1 are acceptable. 0 indicates to clear as Low and 1 means
to keep Hi-Z.
Return data: < NR1 >
SYSTem:ERRor?
It queries the first error message of Error Queue.
Query command format: SYSTem:ERRor[:NEXT]?
Return data: <NR1>,”<String>”
Example: +0,”No error”
SYSTem:CONFigure:DATE
It sets or queries system RTC date.
Set command format: SYSTem:CONFigure:DATE “”
Parameter: <string>
Example: SYSTem:CONFigure:DATE “2016-08-12 16:31:00”
Query command format: SYSTem:CONFigure:DATE?
SYSTem:CONFigure:SAVE
It sets or queries Auto Save Configuration state.
Set command format: SYSTem:CONFigure:SAVE {<NR1>|OFF|ON}
Parameter: < NR1>, 0 (ON) and 1 (OFF) are acceptable.
Return data: < NR1> 0 or 1
SYSTem:AREPORT
It sets or queries Auto Report state.
Set command format: SYSTem:AREPORT {<NR1>|OFF|ON}
Parameter: < NR1>, 0 (ON) and 1 (OFF) are acceptable.
Return data: < NR1>, 0 or 1
SYSTem:MODule?
It sets or queries submodule function and version of system currently.
Set command format: SYSTem:MODule?
Parameter: None
Return data: <NRF>
SYSTem:REMOTE
It sets or queries RS232/Ethernet/USB Device connection state.
Set command format: SYSTem:REMOTE <Boolean>
Parameter: <Boolean>, 0 (ON), 1 (OFF), ON or OFF are acceptable.
Query command format: SYSTem:REMOTE?
Return data: 0 or 1
SYSTem:PRESet
It sets system parameter to return to preset state.
Set command format: SYSTem:PRESet
Parameter: None
Query command format: None
Return data: None