Programmable Bidirectional DC Power Supply 62000D Series
Operating and Programming Manual
1-2
2. Smart fan control: Turn the fan speed from low to high based on the device temperature,
output current and output power to reduce the audible noise.
1.2.3 Output and Indicators
1. Analog outputs are provided to monitor (V/I Monitor) output voltage and current
instantaneously. This allows signals to be easily measured by external instruments
(DMM, Oscilloscope, etc.). The analog monitoring points are stored in the buffer for
protection
2. Output indicator (DC ON) signal.
3. Protection state indication (OVP/AD OCP/DD OCP/OPP/FAN LOCK/AC FAULT, etc.).
4. Over temperature (OTP) protection signal.
5. CV/CC status indicators.
6. Output status indicators.
1.2.4 Control Signals for Input
1. Remote sense input for voltage drop compensation.
2. Analog programming signal allowing the output program and current to be sent using an
analog reference signal.
3. Remote inhibit control signal (TTL)
1.2.5 Measuring and Editing
1. Measurement for voltage, current and power.
2. 10 programs and 100 sequences to edit voltage/current waveform output.
3. Run time voltage program that can be set for up to an hour.
1.3 Specifications
Chroma 62000D Series high power density and bidirectional DC power supplies include
three types of models; 6kW (62060D), 12kW (62120D), and 18kW (62180D). Table 1-1
lists the output specifications of these models. It is suggested to warm up the instruments for
more than 10 minutes before performing verification tests. The test condition is 25 5°C and
under a resistance load.
To Next Page
Loading...
Need help?
General
