Chroma 62000D Series - Can

Manual Operation
3-29
Figure 3-45
2. Tap to set the address.
3. Touch the upper left corner to enter into Menu page.
4. Tap “MEAS. & Setup” to return to the main page.
V valid GPIB addresses are in the range of1~30.
3.2.4.1.4 CAN
The D-series supplies supports remote operation via the CAN bus. It is necessary to set the
baudrate before operating remotely.
1. In the “Interface” page, select CAN as the screen shows in Figure 3-46 or Figure 3-47
shows.
2. Tap Mode to set the bit number.
3. Tap Padding and set it.
4. Tap Baud and set it from the drop-down menu.
5. Tap Cyclic Time to set.
6. Swipe left to second page, then tap ID to set.
7. Tap Mask to set.
8. Tap Cyclic ID to set.
9. Tap SCPI ID to set.