Programmable Bidirectional DC Power Supply 62000D Series
Operating and Programming Manual
3-24
Figure 3-38
3.2.4.1.1 APG
Analog Programming interface (APG) is able to perform the following two functions: 1. use
the analog signal control panel to set the value and 2. Use the analog signal to indicate the
panel measurement. Users can specify the value of set and measured values separately as
described below.
1.
Tap “Interface” and select APG to appear the screen as Figure 3-39 or Figure 3-40
shows.
Figure 3-39
To Next Page
Loading...
